This article describes how to configure SSL Bridging on NetScaler.


An SSL bridge configured on the NetScaler appliance enables the appliance to bridge all secure traffic between the SSL client and the SSL server. The appliance does not offload or accelerate the bridged traffic, nor does it perform encryption or decryption. Only load balancing is done by the appliance. The SSL server must handle all SSL-related processing. Features such as content switching, SureConnect, and cache redirection do not work, because the traffic passing through the appliance is encrypted.

Because the appliance does not carry out any SSL processing in an SSL bridging setup, there is no need for SSL certificates.

Citrix recommends that you use this configuration only if an acceleration unit (for example, a PCI-based SSL accelerator card) is installed in the web server to handle the SSL processing overhead.

Before you configure SSL bridging, first enable SSL and load balancing on the appliance. Then, create SSL_Bridge services and bind them to an SSL_Bridge virtual server. Configure the load balancing feature to maintain server persistency for secure requests.


After enabling SSL and load balancing, create two servers, s1 and s2. Create two SSL_Bridge services, sc1 and src2. Create an SSL_Bridge virtual server and bind the SSL_Bridge services to the virtual server to complete the configuration. At the command line, type:
enable ns feature SSL LB
add server s1
add server s2
add service src1 s1 SSL_BRIDGE 443
add service src2 s2 SSL_BRIDGE 443
add lb vserver ssl_bridge_vip SSL_BRIDGE 443
bind lb vserver ssl_bridge_vip src1
bind lb vserver ssl_bridge_vip src2

Applicable Products


Join the conversation

Citrix Discussions

Open a case

Citrix Support